top of page
  • Melanotan User

Peptides Australia - MT2 Dosage

MELANOTAN 2 Melanotan 2 has a life of 36 hours in your body, this allows you to be very flexible with dosing. Recommended dosages start at 250mcg every day to help your body acclimatize to the peptide and minimize the side effects. You can continue with this dose indefinitely if you are intending to do a low dosage regimen. If you want to dose higher, after 2-4 days, whenever you feel comfortable, up the dose to 500mcg. 500mcg is the most common dosage amount administered by users. You can increase the dose as far as about 1mg but any higher is generally not advised and the users dosing 1mg/dose normally weigh around the 100kg mark.


LOADING DOSE (Melanotan 2) The below dosing plan is based on the vial being reconstituted with 2ml of water.

Day 1-3: 0.25mg/Day – Pull the syringe up to halfway between the bottom and the 10 mark

Inject just before going to sleep to let the peptides work overnight. Any problems that may arise will do so overnight, thus upon waking the user will know how their body will react. Ideally, the user should not feel anything. An antihistamine can also be taken 1-2 hours before injection to ward off any potential side effects.

Day 4-6: 0.5mg/Day – Pull the syringe up to the 10 mark

Day 7 –Until you have your Desired Tan Depth Dose the advised units as per your weight and results per day up to a maximum of 1mg/day.



“Clinical studies have shown that Melanotan works without the need to combine it with any UV exposure, although results are achieved much faster when you incorporate 1-2 tanning sessions either the natural sun or ultraviolet with your Melanotan dosage. The reason for this is while Melanotan significantly raises your levels of melanin, which is the brown pigment that gives your skin its tanned appearance, UV rays are an important factor in discharging your body’s melanin to the surrounding skin tissue.”



MAINTENANCE DOSE (Melanotan 2) Once you have reached your desired level of tan then you can enter what is known as the 'maintenance phase'. Maintenance dosing requires much less frequent dosage than once a day. Although levels are different for everyone on average 500mcg every 3 to 4 days or 1mg a week with a small amount of UV exposure will maintain your tan. This is maintenance dose, as the name implies, to maintain the established colour without darkening the skin further.

The maintenance dose can be continued indefinitely; however, if chosen to cease dosing for an extended amount of time the user’s sensitivity to the peptide will return, making it easy to reduce pigmentation and then rebuild the tan to the desired level.




EQUIPMENT

• Insulin Syringe Typically, insulin needles are to be used to inject or mix the peptide. These needles are 29 to 30 gauge by ½” with a 1 CC (100 units) capacity. It's possible to use larger syringes, however getting precise measurements can be difficult.

If you wish to use doses of less than 500mcg it would be best to use 2ml (200 units) of water. If you wish to use doses of 500mcg or more then you can use 1ml (100 units). This allows you to accurately measure doses while not having to inject more fluid than required.

Volume of insulin syringes is measured in IU (International Units) 100 IU = 1 ML 10 IU = 0.1 ML

If you reconstituted with 1ml of water every unit is 100mcg of Melanotan. If you want to dose 500mcg, you need 5 units. If you want to dose 1000mcg, you need 10 units.

If you reconstituted with 2ml of water every unit is 50mcg of Melanotan. If you want to dose 100mcg, you need 2 units. If you want to dose 250mcg, you need 5 units. If you want to dose 500mcg, you need 10 units.

DO NOT REUSE DISPOSABLE SYRINGES, doing so is dangerous and can have serious health consequences (ie: bacterial infection and abscess formation).

DO NOT SHARE SYRINGES, doing so is dangerous and will lead to the spread of infections (ie: blood borne viruses) found in any one of the individuals sharing a needle (ie: HIV-AIDS, Hepatitis C, etc.).

• Sterile Water Opened sterile injectable water should be disposed of after first use.

NEVER USE TAP WATER AS IT IS UNSAFE AND WILL LEAD TO BACTERIAL INFECTIONS OR OTHER COMPLICATIONS ARISING FROM OTHER CONTAMINANTS. Use only in date MEDICAL GRADE water sold specifically for injection purposes.

• Alcohol Swab Always make sure you wipe the rubber stopper before inserting the needle and your skin at the injection site prior to injection.

ALWAYS MAKE SURE YOUR HANDS ARE CLEAN TO PREVENT THE RISK OF INFECTION



HOW MUCH DO I NEED?:


• Insulin Syringe Typically, insulin needles are to be used to inject or mix the peptide. These needles are 29 to 30 gauge by ½” with a 1 CC (100 units) capacity. It's possible to use larger syringes, however getting precise measurements can be difficult.

If you wish to use doses of less than 500mcg it would be best to use 2ml (200 units) of water. If you wish to use doses of 500mcg or more then you can use 1ml (100 units). This allows you to accurately measure doses while not having to inject more fluid than required.

Volume of insulin syringes is measured in IU (International Units) 100 IU = 1 ML 10 IU = 0.1 ML

If you reconstituted with 1ml of water every unit is 100mcg of Melanotan. If you want to dose 500mcg, you need 5 units. If you want to dose 1000mcg, you need 10 units.

If you reconstituted with 2ml of water every unit is 50mcg of Melanotan. If you want to dose 100mcg, you need 2 units. If you want to dose 250mcg, you need 5 units. If you want to dose 500mcg, you need 10 units.

DO NOT REUSE DISPOSABLE SYRINGES, doing so is dangerous and can have serious health consequences (ie: bacterial infection and abscess formation).

DO NOT SHARE SYRINGES, doing so is dangerous and will lead to the spread of infections (ie: blood borne viruses) found in any one of the individuals sharing a needle (ie: HIV-AIDS, Hepatitis C, etc.).

• Sterile Water Opened sterile injectable water should be disposed of after first use.

NEVER USE TAP WATER AS IT IS UNSAFE AND WILL LEAD TO BACTERIAL INFECTIONS OR OTHER COMPLICATIONS ARISING FROM OTHER CONTAMINANTS. Use only in date MEDICAL GRADE water sold specifically for injection purposes.

• Alcohol Swab Always make sure you wipe the rubber stopper before inserting the needle and your skin at the injection site prior to injection.

ALWAYS MAKE SURE YOUR HANDS ARE CLEAN TO PREVENT THE RISK OF INFECTION

HOW MUCH DO I NEED? How many uses you will get out of a vial all depends on what dose you are taking, but as a rough guideline each vial contains 10mg's of Melanotan with most people (especially females) dosing 0.5mg so you will roughly get 15-20 uses out of a vial.

Depending upon your natural skin tone and how much sun exposure you are getting 1-2 vials is usually enough for your loading phase and to start developing your tan. If you are lighter complexion you may need up to 3 vials (3 months’ worth) for your loading phase. Once you have reached your desired colour you then move on to the maintenance phase which you do not dose as regularly and the vial lasts you a lot longer.



2,772 views3 comments

Recent Posts

See All

Optimal Storage Temperature for Peptides

The Right Temperature for Storing Reconstituted Peptides Reconstituted peptides play a critical role in various fields, including research, medicine, and cosmetics. Whether you’re a scientist conducti

Melanotan 2 Information

Melanotan 2 tanning injections for sale – The wow factor for your skin It’s deeply ingrained in history that bronzed skin is a token of beauty. There’s one caveat: what is perceived as gorgeous often

3 Comments


Angela Noble
Mar 16, 2020

Scam

Like

Angela Noble
Mar 16, 2020

Scam

Like

Angela Noble
Mar 16, 2020

Scan

Like
bottom of page